Scorpion HK-2520 Motor Shaft Kit(3.5mm)

Specifications

The Scorpion HK-2520 motors are built with 4mm hardened steel shafts that will last through countless hours of flying fun, but occasionally, on a "Less than Perfect" landing, you may bend or break one. For these occasions, we offer factory replacement shafts for all the 64.5mm Scorpion Motors.

The shaft for the HK-2520 motors measures 4mm in diameter, and is 64.5mm in length. The shaft kit will also fit other brushless motors that require a 3.5mm output shaft of this length. The shafts can be cut shorter with a Dremel tool and a cut-off wheel if necessary to fit other motors.

Note: The shafts in the Scorpion motors are a slight press fit into the aluminum front housing. The shafts will not just slide out when the setscrews are removed. They need to be pressed out in a bearing press, or in a drill press, with the front housing of the motor supported in a block of wood to prevent warping the front housing.

Weight including packaging

6g

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below: