JR PROPO Three tail blade holder set Ø6 Silver

Having extra tail rotor will increase the rudder control speed as well as holding power. Included, Tail center hub 6mm, Tail PC plate, Metal tail blade holder assembly, Tail slide ring assembly Tail slide ring sleeve, Blade bolt set, other screws Note, * When fitted to the Forza700, No.62056 Metal front bevel gear T22 assembly is required. * Tail rotor blade is not included in this set. If your helicopter uses a torque tube tail drive, we recommend using No.62085 carbon tail rotor blade XB92-TR3 to reduce tail load. Installation example :
Conversion compatibility	:	Forza 700, VIBE 90SG, VIBE SG E12, etc (helicopters with 6mm diameter tail output shaft)

 

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below: